深圳市亚美德(Rmede)科技有限公司 battery charger,12 volt battery chargers , china battery charger manufacturer

Industry News

  • Hook a Car Amp to a Battery Charger(2011-06-21 23:13)

     Disconnect the power wire from the amplifier to ensure that no power goes to the amp. Ensure that the battery charger is turned off.     Cut the wire t...

  • Auto Battery Charger Work?(2011-06-14 15:42)

    * Batteries: Electricity stored and restored Automotive batteries are devices that convert stored chemical energy into electric voltage. A battery charger is a devi...

  • Making a Battery Charger(2011-06-14 15:39)

    MakingTo create a battery charger, you will need a power source that will output voltage equal to the battery voltage. For example, since most automotive batteries are ra...

  • Battery Charger Work?(2011-06-14 15:38)

    A battery works by having two or more metallic plates immersed or surrounded by a material called an electrolyte. The electrolyte in an automotive battery is sulfuric aci...

  • Revive AA NiCad Batteries(2011-06-14 15:25)

    Turn on your device with your charged NiCad battery installed. Check the power reading to make sure that your battery is fully charged.     Open as many appl...

  • Make a Portable Power Charger(2011-06-11 20:00)

    Set the 12-volt deep cycle battery into the wooden box. This box will become the housing of the portable charging device.     Place screws in the screw holes...

  • Battery Charger Instructions(2011-06-09 23:33)

    Set the battery charger to the correct voltage, usually 12 volts for a car.   Switch the output selector to the desired number of amps. The lower the number of amp...

  • Battery Charger & Jump Start(2011-06-09 23:30)

     If your battery does not have enough charge to start your engine there are two options for getting your car started: Jump starting the car or using a battery charge...

  • When Old Analog Car Battery Chargers Are Finished?(2011-06-08 10:13)

    Two types of automotive battery chargers are sold commercially: "smart" battery chargers and analog battery chargers. A smart battery charger takes the guesswor...

  • Build a Lead Acid Battery Charger(2011-06-08 10:11)

    Pull apart the wire ends of the electrical cord until there is a four-inch separation between the wire ends. Strip the wire ends of 1/2 inch of insulation.    ...

  • Hook Up an Onboard Battery Charger(2011-06-08 10:02)

    Unwrap the wires on the onboard charger and check the length. The charger should be located in a position easily visible and where all wires reach the batteries.   ...

  • Build Your Own 9 Volt Battery Charger(2011-06-02 09:55)

    Review the transformer schematic that came with the transformer. Identify the two primary terminals. Strip 1/2 of an inch of insulation off of the two wires of the power ...

  • Build a 9V Battery Charger Circuit(2011-06-02 09:53)

    Cut a hole in the side of an Altoids mint box with a Dremel tool to fit a USB cable.     Build a USB charger circuit with about 5 volts needed from a 9-volt ...

  • Build a Battery Charger Circuit(2011-06-02 09:51)

    Strip half an inch of insulation from the ends of the wire equipped with the electrical plug. Connect one of the two wires to one of the terminals on the primary side of ...

  • Use a 12V Battery Charger(2011-06-01 19:20)

     Make sure the battery charger is turned off before plugging it in to a 110-volt outlet.     Set the voltage selector switch to 12 volts if it's a dual ...

  • Use a Roomba Battery Charger(2011-06-01 19:08)

    Push down on the Roomba's power switch, located on the front right side of the device, to turn the Roomba off.     Locate the two holes that are to the left ...

  • Brif introduction of charger(2011-05-31 13:04)

    Brif introduction of charger  When we choose and use a charger, we should follow the data characteristics of battery to fix a suitable one to advoid the possible ...

  • Hook Up an Onboard Battery Charger(2011-05-31 10:11)

     *Unwrap the wires on the onboard charger and check the length. The charger should be located in a position easily visible and where all wires reach the batteries. ...

  • Laptop Battery Charger Problems(2011-05-30 16:46)

    Noise and Buzzing: A light, high-pitched buzz or tone emanating from a laptop battery charger is not uncommon. Typically, you can hear this only if you place your ear cl...

  • Choose the Right AA Battery Charger(2011-05-30 16:25)

    Find out how many AA batteries the charger can recharge at once. If you need to recharge six AA batteries at one time, the "right" battery charger for you will ...

Results 1 - 20 of 102  First page  1  2  3  4  5  6   Last page
Leave your message
Content
Telephone
Email